Kanguru Bio Slider II Uživatelský manuál

1 Kanguru BioSlider II User Manual Trademarks and/or registered trademarks are the property of their respective owners: The informati

10 Chapter 3: Starting the USB BioSlider II The BioSlider II is a removable device to your PC. Plug it into a USB port before using it. NOTE: You h

11 Step 2. Slide your finger down towards the other end of the BioSlider II

12 5. It will require the user to take at least 3 to 7 times to enroll successfully. You can adjust the “level of security” from low to hig

13 It is highly recommended to enter passwords more than six characters in length. 7. A green dot will be shown on the appropriate finger afte

14 become the primary access security Some users may have distinct fingerprint images, others may not. In addition, some individuals may take a s

15 4. Access to the secure encrypted drive will be visible once the correct fingerprint or rescue password is entered. If window does not automatica

16 3. Click the finger that you have previously enrolled, a screen will appear. Select “Yes” if you wish to delete the fingerprint. It is

17 finger drive ring and the sensor surface, follow these steps: 1. Unplug the BioSlider II from the computer. 2. Use any clean soft cloth with a

18 Chapter 4: Recovery If the BioSlider II sensor or the Flash storage itself is damaged, you can use the Recovery tool to restore the unit to its

19 10. Click “OK” to confirm BioSlider II recovery. All files on the drive will be deleted. 11. Follow the on-screen instructions to complete the

2 Please be aware of the following points before using your Kanguru BioSlider II. Copyright© 2007 , Kanguru Solutions. All rights reserved. All br

20 Tech Support If you experience any problems installing your Kanguru BioSlider II or have any technical questions regarding any of our products, p

3 Table of Contents Chapter 1: Introduction………...…………………………………………………...4 Chapter 2: Installation Guide……..………………………………………………...6 Chapter 3: Star

4 Chapter 1: Introduction USB 1.1/2.0 Kanguru BioSlider II Storing, moving, and securing the data has never been easier. The Kanguru BioSlider II i

5 l Windows 98SE with Device Driver l Window 2000/ME and Windows XP System Requirements A. Plug-in the BioSlider II only after the Windows 98

6 Chapter 2: Installation Guide Windows ME/2000/XP Installation No driver installation is required for Window s ME, 2000 or XP operating systems as

7 3. Click “Stop” in the Unplug or Eject Hardware Window. 4. Select “USB Mass Storage Device” and click “OK” 5. Click “OK” and remove BioSlider

8 Make sure the LED is not flashing before removing the BioSlider II. If you remove the BioSlider II while the LED is flashing, it could result i

9 2. When using Windows 98SE, please remove the BioSlider II by unplugging the device. Make sure the LED is not flashing before removing the BioSlid